How to build a hydrogen generator

Did you know that you can run your car on water with a simple hydrogen generator, the which can dramatically increase gas mileage? With high gas prices these days, people are increasingly desperate in the search for ways to increase efficiency of their cars, trucks, motorcycles and trucks. Gas is not getting cheaper and experts forecast that the current uptrend will continue for a long time yet. The result of the hydrogen generator is immense. Not only the production of water on combustion, meaning absolutely no pollution at all, but improving gas mileage.

A hydrogen generator is already in use in laboratories for the supply of high purity hydrogen. Hydrogen generated from the 99.99% purity. They are small in size and weight in general, which occupies 2.1 square feet of bank and weighing 30-60 pounds. Few hydrogen generators require the addition of caustic solution to produce hydrogen gas, but most others require only deionized or distilled water.

We can easily make a hydrogen generator in our homes, the procedure for which is listed below. This is the concept that scientists want applied in the manufacture of cars that would be powered by hydrogen. Things needed: scissors, bottles, knives, carpenter's pencil, telephone wire, glue hot glue gun, tubes, electrodes, the valve

Step 1: Cut the top of a 2 liter bottle plastic funds out of two bottles of 20 oz plastic with a pair of scissors. Cut the larger bottle enough for the two smaller bottles fit comfortably inside it. Be sure to keep the screw in the form of bottle caps.

Step 2: Use a sharp knife to carefully cut away from the wooden roof of the pen leaving you with only the backbone of carbon graphite. Break the initiative in two separate but equal parts with a knife.

Step 3: Remove about ¼ inch of insulation from two phone cables 12 inches extraction forceps before removing more than 2 inches of insulation from the opposite ends.

Step 4: Wrap the exposed copper telephone wire at the end of 2 inches around the edges Pen and secure in place with a little hot glue.

Step 5: Use a drill to drill holes in the middle of the two bottle caps small popup window and attach a 24-inch long piece of plastic aquarium tubing. Secure into place with a little hot glue around both inside and outer perimeter of the hole. Once dry, replace the lids on the bottles screw into place.

Step 6: Place the electrodes the cable connected to the bottom of the two small bottles of soft drinks with hot glue to secure it in place. Place the small bottles in the soda bottle big and hot glue in place to not be moved.

Step 7: Place an aquarium of 2 to 1 mix ratio of the free ends of the pipe before connecting the electrode wires to the correct terminals on a battery of 12 volts. May be an idea to label the positive wire "Anode oxygen "and the negative" cathode of hydrogen. "

If the above model can be used in cars then major global issues such as global warming, rapid depletion of nonrenewable energy sources (fossil fuels) can be treated.

About the Author

To find out more about using water to run your car and get a free question and answer report please visit www.RunCar-OnWater.com

Aquarium Base Construction Part III